We have moved to a new address

8607 E. PECOS RD. BLDG #5, MESA, AZ 85212

Air Conditioning Systems

How Air Conditioning Works

You might have pondered (while stuck on the I60) how the air conditioning actually works, or perhaps you have never given it a moment's thought. Just in case you are curious, let us explain it to you.

Air conditioning like it says 'conditions' the air. It not only cools it down, but also reduces the moisture content, or humidity. All air conditioners work the same way whether they are installed in a building, or in a car. The fridge or freezer is in a way an air conditioner as well. Air conditioning is a field in it's own right, but we'll stick to the main points or a car's air conditioning and the main parts used and a few hints to keep the air-con system running properly.

A number of people don't realise that turning on the air conditioning actually reduces the number of miles per gallon of your car. There is energy used in removing the heat and moisture from the air in the car, and this consumes petrol because of the extra engine load.

Air conditioning's main principles are Evaporation and Condensation, thenCompression and Expansion. To the engineer and physicists they talk of thermodynamics - but we'll explain it in our own way here:

Mesa Auto Air Conditioning Repair - Dana Bros. Automotive & Diesel Repair

Evaporation: You may have noticed that if you rub a little surgical spirits on the back of your hand, then your hand will feel cold. Why is that? It's evaporation. It is because the spirits on the back of your hand start to evaporate. As the spirit evaporates, it takes away heat from the surface of your skin.

Condensation: Have you ever noticed when somebody walks in from the cold into a take-away wearing glasses, their glasses steam up? Why is that? It's condensation. The moist air of the take-away cools as it contacts the cold surface of the glasses and the air has less capacity to hold moisture, so it condenses into water on the glasses.

Heat of Compression: Have you ever noticed when you pump up a bicycle tyre with a hand pump, that the end of the pump gets hot? This is because the energy that you have put into the air by pumping it has not only compressed it, but has also caused the air molecules to push closer together so giving off heat with the friction.

Compression: At some point all gases will eventually become liquid. An example of that would be a can of deodorant - it's liquid inside the can (because you can hear it when you shake it) but is a gas when it comes out and hits your underarm. The pressure inside the can is higher, so the propellant inside is liquid.

Cooling by Expansion: Going back to the deodorant, you will notice also how cold it feels that's because the propellant has just expanded in volume quickly.

Anyway, enough about takeaways, armpits and surgical spirits, but those are the basic ideas that are easy enough to explain. The important question is how does all this fit into making your car's vents blow cold?

Hard tubing and flexible hoses connect all the actual components of the air conditioning in your car. Evaporation and condensation, expansion and compression are the physics of why it works. There are five main components to the whole system, namely the Compressor, Condenser, Receiver-dryer, Expansion valve, and the Evaporator.

The fluid that passes around the whole system is the refrigerant. The refrigerant can evaporate at a low temperature, and then condense again at a higher pressure. In the bad old days, R-12 was the refrigerant used in almost all cars. It was widely available, however it was found to be a contributor to the hole in the earth's ozone layer as it was a chlorofluorocarbon (CFC). These refrigerants were discontinued, and all cars after 1996 use a non-CFC fluid called R-134A which is kinder to the environment.

So, here is how all the various parts of a car's air conditioning works:

Compressor: The compressor is the work horse of the air conditioning system, powered by a drive belt connected to the crankshaft of the engine. When the aircon system is turned on, the compressor pumps refrigerant vapour under high pressure to the condenser.

Condenser:The condenser is a device used to change the high-pressure refrigerant vapor to a liquid. It is mounted in front of the engine's radiator, and it looks very similar to a radiator. The vapour is condensed to a liquid because of the high pressure that is driving it in, and this generates a great deal of heat. The heat is then in turn removed from the condenser by air flowing through the condenser on the outside.

Receiver: The now liquid refrigerant moves to the receiver-dryer. This is a small reservoir vessel for the liquid refrigerant, and removes any moisture that may have leaked into the refrigerant. Moisture in the system causes havoc, with ice crystals causing blockages and mechanical damage.

Expansion Valve: The pressurised refrigerant flows from the receiver-drier to the expansion valve. The valve removes pressure from the liquid refrigerant so that it can expand and become refrigerant vapour in the evaporator.

Evaporator: The evaporator is another device that looks similar to a car radiator. It has tubes and fins and is usually mounted inside the passenger compartment behind the fascia above the footwell. As the cold low-pressure refrigerant is passed into the evaporator, it vaporises and absorbs heat from the air in the passenger compartment. The blower fan inside the passenger compartment pushes air over the outside of the evaporator, so cold air is circulated inside the car. On the 'air-side' of the evaporator, the moisture in the air is reduced, and the 'condensate' is collected and drained away.

Compressor:The compressor then draws in the low-pressure refrigerant vapour to start another refrigeration cycle. The refrigeration cycle then runs continuously, and is regulated by the setting of the expansion valve.

The whole process is reasonably simple when explained like that. All air conditioning systems work on the same principle, even if the exact components used may vary slightly between car manufacturers.

We hope that explains a little as to how that little 'A/C' button works on your car, if you want it explained a little more in depth then if you roll up your sleeves we can show you the components in your car next time you bring it infor a check or service here at Dana Brothers Automotive.

Dana Bros. Automotive & Diesel Repair is committed to ensuring effective communication and digital accessibility to all users. We are continually improving the user experience for everyone, and apply the relevant accessibility standards to achieve these goals. We welcome your feedback. Please call Dana Bros. Automotive & Diesel Repair (480) 272-3496 if you have any issues in accessing any area of our website.